Are you attempting to set up a new home theater system or some speakers? The easiest way is to hire a competent installer to aid you. On the other hand, you might consider doing the setup yourself. I will outline the basic setup procedure and present some tricks to help stay away from some widespread problems.
Your home theater system will normally include 5 or 7 loudspeakers – one main loudspeaker, two front speakers, two rears as well as two sides (in case of a 7.1 system) in addition to a subwoofer. It also comes with a main element. This element will drive all of your speakers. This central component is also referred to as surround sound receiver or amplifier. It is the main hub of your home theater system. Make certain that you put this receiver in a location which is fairly centrally positioned in order to minimize the amount of speaker wire which you need to run. You don’t inevitably need to place the receiver right next to your TV. Just make sure it is in a dry and safe place. In addition, be sure that you can easily reach the receiver from your television set or DVD/Blue-ray player because you will need to connect those. Attaching the receiver to power and to your television set or Blue-ray player is pretty easy. Most modern TVs include an optical output which connects straight to your receiver using a fiberoptical cord. This cable is generally included with your system. You may also get it a most electronics shops. After you have established the audio connection to your TV, you can now go ahead and connect your speakers. This step demands a little more effort.
Determine the length of loudspeaker wire that you are going to require for connecting all of the satellite loudspeakers. Ensure to add some extra cable to take into account those bends and corners. If you are planning to drive a lot of power to your speakers then be sure you select a cable that is thick enough to handle the current flow. Your woofer is going to usually have a built-in power amplifier and attach to your receiver via RCA cable. The loudspeaker cord connects to every speaker by the speaker terminals. These terminals are color coded. This helps observe the right polarity while connecting the loudspeaker cord. Most loudspeaker cable will show one strand in a different color. This is essential since it is going to help guarantee the right polarity of the loudspeaker terminal connection. Just connect the different-color strand to the speaker terminal which is colored. Then, whilst attaching the speaker cord to your receiver, make sure that you connect the cord to each loudspeaker terminal at the receiver in the identical manner. This will keep the sound going to each speaker in the right phase and optimize your sound experience. Wireless speakers usually need to employ some amount of audio buffering during the transmission to cope with wireless interference. This results in a brief delay while the audio is broadcast. This delay is also known as latency and should be taken into consideration during your set up. Ideally, all loudspeakers have the same latency and as a result are in perfect sync. If you have both wireless as well as wired loudspeakers, the wireless speakers will be out of sync with the wired speakers. Thus you will have to delay the audio going to the wired speakers by tweaking your receiver. The amount of delay should be identical to the latency of the cordless loudspeakers. Confirm with the manufacturer if your surround receiver can be set to delay the audio of particular channels. If you are using wireless rears, you want to set the front-speaker and side-speaker channels to delay the signal. Home theater systems that were not designed for wireless rear speakers might not have this ability. In this case you may wish to look for a wireless speaker kit which has very low latency, ideally less than one ms. This is going to keep all of your speakers (Read this regarding outdoor stereo speakers) in perfect sync. Uncover further materials at http://www.sonos.com/.